This is a public forum thread open to all users

Rust proofing.

Richard Morris
Topic Author
Offline
Elite Member

1 year 7 months ago - 1 year 7 months ago #43814 by Richard Morris

Rust proofing. was created by Richard Morris

Nick troth did a thorough waxoyling when we first had the car, and again a couple of years later. I’ve just used lanoguard to go over the car again. There was no rust at all to start with, but a top up isn’t going to harm. I’m planning on doing the 2cv next and then my modern fiat.

1988 SE in mica blue
1985 Citroën 2CV6
2021 Fiat TIPO Cross

Last edit: 1 year 7 months ago by Richard Morris.

Please Log in or Create an account to join the conversation.

Garry Ursin-smith
Offline
Elite Member

1 year 6 months ago - 1 year 6 months ago #43815 by Garry Ursin-smith

Replied by Garry Ursin-smith on topic Rust proofing.

Yes i understand lanoguard is good but you have to renew it yearly with it, wheras waxolyn stays alot longer

Last edit: 1 year 6 months ago by Garry Ursin-smith.

Please Log in or Create an account to join the conversation.

ricardo a p roadnight
Offline
Senior Member

1 year 6 months ago #43827 by ricardo a p roadnight

Replied by ricardo a p roadnight on topic Rust proofing.

i used 15 litres of ankor wax , sprayed in every hole after removing the factory grommets , and on all the panels inside and the inside of doors , i then drilled holes in the sills the top of them , and the door box sections , and sprayed 5 cans of bol cavity wax in them i sprayed the coil springs and the brake lines as well

Please Log in or Create an account to join the conversation.

Time to create page: 0.130 seconds