bleeding

To get all the air out of the coolant system I sent off for a tee bleed valve from Car Builder Solutions 16mm. It came next day, today and I have just fitted it.
I already had a joiner at the heater circuit high point that I used for filling but I removed that and fitted the "tee".
I bled the radiator first, then the "tee".
The photos show the "Tee". Good construction, a brass valve with a spiral groove in the valve.
Then I though that I would pressure bleed the system. I had a pasty yesterday plus two pints of Tribute so I was up to the job.
The photos speak for themselves.
I hope this is useful.