visors

Yes. getting the plastic was difficult but i cut them out yesterday and should finish them today. Got the dark blue and the smoked grey

Thanks David, looking forward to receiving mine!

Cheers R

Thanks David. Mine arrived today and look good. The holes seem closer together than my original visors but I'm sure we can extend them. The only problem now is getting the blasted screws out of the old visors. They have silly screw fitting with a screw through the middle of it.☺

Me too! Thanks David

There is space on the shafts for the mounting clips to go in and out a bit. Getting them tight was a problem but I got my dremel on to the job so I could nip them up a bit tighter.
I used two screw drivers to get the clip off.

I hope you get them to fit well, I have been a bit nervous, using a Dremel on the clip allowed me to nip them up to fit tight on the spindles.