- Posts: 231
- Thank you received: 6
This is a public forum thread open to all users
WANTED! Passenger side engine vent plastic trim
- Jack McConchie
-
Topic Author
- Offline
- Elite Member
-
Less
More
14 years 4 months ago #25497
by Jack McConchie
WANTED! Passenger side engine vent plastic trim was created by Jack McConchie
You know the one.. the one that scoops up cold air into the engine compartment from just in front of the rear wheel..
Mine popped off today and the heads round the screws that hold it in have sheared.
SO ideally I need the trim, the screws and the two little clips that give the screws something to bite..
Thanks!
Mine popped off today and the heads round the screws that hold it in have sheared.
SO ideally I need the trim, the screws and the two little clips that give the screws something to bite..
Thanks!
Please Log in or Create an account to join the conversation.
- Michael Erskine
-
- Offline
- Platinum Member
-
14 years 4 months ago #25500
by Michael Erskine
I have had that many Fiats they gave me a job selling them
Replied by Michael Erskine on topic WANTED! Passenger side engine vent plastic trim
Will check the garage tomorrow night think I have one might also have a carb for a 1500
Michael
Michael
I have had that many Fiats they gave me a job selling them
Please Log in or Create an account to join the conversation.
- Jack McConchie
-
Topic Author
- Offline
- Elite Member
-
Less
More
- Posts: 231
- Thank you received: 6
14 years 4 months ago #25502
by Jack McConchie
Replied by Jack McConchie on topic WANTED! Passenger side engine vent plastic trim
Thanks Michael. Actually, the reason I'm after a carb is because mine needs a thorough cellulose soak and it's any every day car so I can't afford any down time. I could give you my carb in return or something if it suited..
Please Log in or Create an account to join the conversation.
- Jack McConchie
-
Topic Author
- Offline
- Elite Member
-
Less
More
- Posts: 231
- Thank you received: 6
14 years 4 months ago #25503
by Jack McConchie
Replied by Jack McConchie on topic WANTED! Passenger side engine vent plastic trim
Also, did you ever hear from your man at the garage? I sent you a pm a while back, but have been slowly making progress with bits and bobs..
Please Log in or Create an account to join the conversation.
- Michael Erskine
-
- Offline
- Platinum Member
-
14 years 4 months ago #25504
by Michael Erskine
I have had that many Fiats they gave me a job selling them
Replied by Michael Erskine on topic WANTED! Passenger side engine vent plastic trim
Will chase him tomorrow or I might have another contact long story will pm you my number
Michael
Michael
I have had that many Fiats they gave me a job selling them
Please Log in or Create an account to join the conversation.
Time to create page: 0.154 seconds