Hi,
Looking for a pair (n/s & o/s) inner boot floor quarter panels. They are the funny little panels in each corner of the boot - where the jack sits etc.
Yes - spoke to Claire today and she's managed to get a set made quickly for me.
Mark i know your a wizard with the welder - any tips on fitting these panels?
Hi Mick
the floors are only welded in two places, against the back inner wing and onto the inner boot wall the other two sides are filled with panel joint sealer, i cut out the old floor and left a 2 cm lip around the welded section and then welded the repair panel straight onto the lip, i drilled out about 8 holes and filled with weld then seam sealed the other two sides,
looks fine and kept the original look
I use a 150amp gas-less Mig welder with .9mm wire and it welds great
Sorry, this website uses features that your browser doesn’t support. Upgrade to a newer version of Firefox, Chrome, Safari, or Edge and you’ll be all set.
